#Restore crc and checksum on project 64 emulator driver
Usbcore: registered new interface driver hub Usbcore: registered new interface driver usbfs Pinctrl-at91 initialized AT91 pinctrl driverĪt_hdmac ffffe600.dma-controller: Atmel AHB DMA Controller ( cpy set slave ), 8 channelsĪt_hdmac ffffe800.dma-controller: Atmel AHB DMA Controller ( cpy set slave ), 8 channels Gpio-at91 fffffa00.gpio: at address (ptrval) Gpio-at91 fffff800.gpio: at address (ptrval) Gpio-at91 fffff600.gpio: at address (ptrval) Gpio-at91 fffff400.gpio: at address (ptrval) Gpio-at91 fffff200.gpio: at address (ptrval) Pinctrl core: initialized pinctrl subsystemĭMA: preallocated 256 KiB pool for atomic coherent allocationsĪT91: PM: standby: standby, suspend: ulp0 VFP support v0.3: implementor 41 architecture 2 part 30 variant 5 rev 1Ĭlocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 1911 2604462750000 nsįutex hash table entries: 256 (order: -1, 3072 bytes, linear) Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes, linear)
Mount-cache hash table entries: 1024 (order: 0, 4096 bytes, linear) Switching to timer-based delay loop, resolution 60nsĬalibrating delay loop (skipped), value calculated using timer frequency. Sched_clock: 32 bits at 16MHz, resolution 60ns, wraps every 130150523873ns Random: get_random_bytes called from 0xc0b00bb4 with crng_init=0Ĭlocksource: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_n s: 115833966437 ns NR_IRQS: 16, nr_irqs: 16, preallocated irqs: 16 Mem auto-init: stack:off, heap alloc:off, heap free:off Inode-cache hash table entries: 16384 (order: 4, 65536 bytes, linear) Kernel command line: console=ttyS0,115200 earlyprintk mtdparts=atmel_nand:256k(b ootstrap)ro,768k(uboot)ro,256K(env_redundant),256k(env),512k(dtb),6M(kernel)ro,- (rootfs) rootfstype=ubifs ubi.mtd=6 root=ubi0:rootfsĭentry cache hash table entries: 32768 (order: 5, 131072 bytes, linear) Initmem setup node 0 īuilt 1 zonelists, mobility grouping on.
Linux version 5.10.50-linux4sam-2021.04 (arm -buildroot-linux-gnueabihf-gcc.br_real (Buildroot linux4sam-2021.04) 9.3.0, GNU ld (GNU Binutils) 2.35.2) #1 Fri Dec 10 12:24:ĬPU: ARMv7 Processor revision 1 (ARMv7), cr=10c53c7dĬPU: PIPT / VIPT nonaliasing data cache, VIPT aliasing instruction cache Loading Device Tree to 2fb29000, end 2fb35bb9. Hit any key to stop autoboot: 0 NAND read: device 0 offset 0x180000, size 0x80000ĥ24288 bytes read: OK NAND read: device 0 offset 0x200000, size 0圆00000 *** Warning - bad CRC, using default environmen t In: address not set. NAND: Initialize PMECC params, cap: 4, sector: 512 NAND: ECC Correctability Bits: 4, ECC Sector Bytes: 512 NAND: Manufacturer ID: 0x2c Chip ID: 0xda The console output is the following: omBOOTĪT91Bootstrap 4.0.0 ( 12:24:08) NAND: ONFI flash detected The root file system is in NAND (ubi filesystem). Hi, I try to make a build for the SAMA5D3_xplained board that uses the environment.
Problem with Loading Environment from NAND.
0 kommentar(er)
